5/19/2023 0 Comments Cura with repetier serverUse at your own risk! The firmware and Config Files are provided “as is” without warranty of any kind, either express or implied. Read mode about it in the Sidewinder X1 Auto Bed Leveling with Stock Sensor article Disclaimer You can also achieve Auto Bed Leveling on your Artillery Sidewinder X1 using the stock Z endstop sensor. Sidewinder X1 Auto Bed Leveling with Stock Sensor If you want a better cooling duct that works with the firmware settings and BLTouch, you can download my remix from Thingiverse. The firmware including BLTouch can be downloaded from here. You can use the Waggster Mod video for information on how to install the pins. Download the stock Sidewinder X1 TFT screen filesĭue to popular request, the Sidewinder X1 Firmware containing the BLTouch settings is currently available.If you want to revert to the stock screen, follow these steps: Now you can enjoy the new functionality offered by the new firmware. Touch the calibration points on the screen.Turn on the printer and wait for the firmware to finish flashing.Unzip the archive and copy the contents to the SD Card.Download the Sidewinder X1 screen firmware.In order to install the new screen firmware for the Sidewinder X1, follow the steps listed below: You can read more about it here: Custom Screen Firmware for Sidewinder X1 and Genius. Please note that this version of custom LCD firmware is not the same as stock. M501 Flash Artillery Sidewinder X1 custom LCD Firmware You can also run the following commands in sequence: ![]() gcode file on your SD Card and “print” it. The stock TFT touchscreen cable needs to be removed in order to get a connection from the computer and flash the board firmware.Īfter flashing the firmware, make sure you first run the G-Code provided, to reset to factory defaults and clear EEPROM. More information is covered, to better understand the process. Please read the full article before starting the flash.
0 Comments
Leave a Reply. |